![]() 28BYJ-48 Driver Module-improved.fzpz (17.3 KB) 28BYJ-48 Stepper Motor-improved.fzpz (8. and the output gerber files for the sketch. Start / Peak Current: 2A (continuous pulse) / 3. Here is the complete test sequence of the two parts (including gerber output) 869×804 109 KB. ![]() ![]() Output Current: 1.2A (single-channel continuous drive current).It is a good choice for DIY project or product developments. Standard XH2.54 pin can be inserted directly into the breadboard. The control logic is similar to L298n, and the code can be directly compatible with the DFROBOT L298N motor driver. The maximum continuous drive current of single channel can reach 1.2A, peak value 2A/3.2A (continuous pulse / single pulse), which can drive some micro DC motors. TB6612FNG is a dual-channel full-bridge drive chip. Compared with the IC Breakout, it saves two precious GPIO resource, especially in Arduino UNO board. It inherits DFRobot L298N motor control logic, which only need four pins to drive 2 motors. This DFRobot micro dual way DC motor driver is design based on TB6612FNG motor driver IC. 2x1.2A DC Motor Driver (TB6612FNG) wiki- DFRobot
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |